Supply List:

2- 2’’ x 2’’ x 8’ boards (actual- 1 1/2’’ x 1 1/2’’ x 96’’)

2- 2’’ x 3’’ x 8’ boards (actual-1 1/2’’ x 2 1/2’’ x 96’’)

1- 2” x 6’’ x 8’ board (actual-1 1/2’’ x 5 1/2’’ x 96’’)

3- 2’’ x 10’’ x 8’ boards (actual- 1 1/2’’ x 9 1/4’’ x 96’’)
Miter Saw or Circular Saw
Drill and Driver
Kreg Jig Hole System
Sander
Tape measure
Clamps

Step 1:  Cut wood, drill pocket holes and sand

Cut all your wood to the specified dimensions using a Kreg Jig and drill 1 1/2'' pocket holes into each end of your 4-2x2 apron supports and your 6 rails and 1 middle support pieces.

Step 2:  Build your sides

Build two sides by attaching your rails to your sides with pocket hole screws.

Step 3: Add Aprons and Support boards

Using wood glue and 2 1/2'' pocket hole screws attach your top aprons and support pieces to your sides.  Note:  You will also add your middle support boards in the center of the top aprons (not pictured), I added it as a last minute support board.

Step 4:  At this point I did my finish on my frame and the top and shelf boards before I proceeded with the rest of the build, this is optional.

Step 5:  Add top and Shelf boards to frame.

Click here to purchase and download the DIY Console Table Plans